New MP3500RSG Waste Oil/Bulk Oil Transfer Filtration Pump,100 PSI,Biodiesel,WVO,

Description

FOR MORE INFORMATION ABOUT OUR PUMPS, GO TO REDLINEPUMPS DOT COM OR CALL 1-605-881-3473.
This is our
Heavy Duty Redline MP3500RSG
110 Volt Transfer System which features a high quality
1/2 HP Industrial Grade Reduced Speed 110 volt motor. It has a 3/4" Port 12 GPM Gear Head
.
It can transfer heavy oil up to 140 wt. It will also pump cold oil!
This system comes with a full 1 year warranty! We build this unit here in our shop in Watertown, SD and handle all service or warranty work here. This unit works great for
bulk or waste oil.
This redlinepump includes a
3/4" port
heavy duty cast iron pumping unit with steel helical gears
, a
reduced speed motor which increases the pumps power,
a 3 piece flexible drive system, a heavy duty steel frame with carry handle, and a power cord with plug end. This pump has an adjustable pressure relief system which produces up to 100 PSI. It can be used for a centrifuge. The pressure adjust bolt is on the back of the pump. Turning it in increases the pressure and turning it out reduces the pressure. You can also mount a filtration system on the pressure side of the pump. Output rates vary with the type of oil and it's temperature. Diesel pumps at 12 GPM. WVO at room temperature will pump at 12 GPM.
15w40 diesel engine oil will pump at up to 10 GPM when it is above 50 degrees in temperature.
These pumps are better than other pumps because they have the power to self prime. It is better to have shorter suction hoses when possible because longer suction hoses will slow your flow rate. Another huge plus this pump offers is
NO DUTY CYCLE!
You can use it as long as you like without having to shut it off to cool. Other pumps you may see have duty cycles of 20 minutes or less. If you run them past their duty cycle their cheap little motors melt.  Many of them were never intended to pump any type of oil. Just water or diesel. Thin, easy to pump liquids- not thick oil. Again, redlinepumps are purpose built to move waste oil. They have a cast iron positive displacement gear pump instead of a cheap rubber flexible impeller or light duty composite or plastic blades that run inside of round chamber. As far as durability goes, a gear pump is best. All you need is a 1000 micron screen to keep out larger debris. 1000 micron is equal to screen door screen. Small vegetable matter (1000 Micron and smaller) has no effect on our gear pumps. Many other pumps you may find have to be screwed into a 2" bung on a barrel in order to suck out the oil. This is very inconvienient when you need to move the pump around to remote locations. With our system, you can put the pump where you want to and roll out a suction hose to your oil source and pump out the oil. A redlinepump is a purpose built system which makes oil transfer fast and easy. Also, with our pumps
1/2 HP
Industrial Grade Reduced Speed Motor,
you"ll have the power you need to transfer oil even when it's thick or cold. With this pumps reduced speed motor (a typical motor turns at 1800 rpm)  the pump turns at around 1100 rpm. Other pumps on the market do not offer this. This is why they fail when you try to pump a heavy or thick oil with them. Their pumping units and motors turn at 1800. No good for the tough jobs like oil filtration or cool weather oil transfer. This system uses 1" ID hose if warm or cold oil is to be pumped.
We offer 1" oil hose for .00 per foot.
Suction wands with screens are .00.
A complete hose kit with two 10 foot hoses, a full set of cam lever quick couplers, and a suction wand is 5.00.
We offer a full line of accessories on our site.
Please call 1-605-881-3473 with any questions. Shipping is .00 to the lower 48 states. Canada shipping is 0.00.   Thanks,  redlinepumps  David L. Miller